|
Accessory or Product |
Comments |
| H-D Floating Brake Rotors on the front #44358-00 |
Easy install. Just remove the wheel and
bolt on. |
| Lyndall Z Brake Pads |
Made a big difference in braking |
| Vance & Hines Monster Ovals Slip-ons |
They sound great. Deeper sounding and
not as loud as the Ovals I had before. |
| Vance & Hines Dresser Duals |
Had my indy install them. |
| H-D SE Pro Race Tuner and Dyno |
Tuned by Indianapolis Southside H-D |
| H-D Leather Windshield Bag |
Good place to keep small items like garage
opener |
| H-D Siren for Security System and Pager |
Easy - Mounts under ECM and connects to factory
security alarm. |
| H-D Hand Air Pump for suspension |
Makes airing up the shocks easy. |
| H-D Sissy Bar with Detachable System # 53803-06 |
Somewhat confusing because the instructions and parts
are for several model bikes. Took about 2 hours. |
| H-D Speedometer / Tach Combo |
Pretty easy. Had to grab some slack in the
electrical connection wires because the plug on the new speedometer is
orientated up and the original is down. Not bad. Looks great |
| H-D Detachable Solo Rack
53048-06 |
Uses the same mounts # 53803-06 as the Sissy Bar |
| H-D Cruise Control |
Installed it in about 3 hours. Lots of steps but
not bad. Helps to have a son in-law to help. Thanks Mike. |
| H-D Rear Bumper Light |
Easy install. I hooked it up to my brake lights. |
| H-D Chrome LED Tail Light #68085-08 |
Replaces the original with a nice chrome
LED system |
| H-D Run Brake Turn Signal Module #
69461-06A |
Converts rear turn signals to brake light
with red lens. |
| XP BackOff Module from
Signal Dynamics |
Flashes brake lights 5 times and then on
steady |
| H-D V-Wing Inspection Cover |
Just replaces the original. |
| H-D Saddlebag Guard Rails # 91216-97 |
Easy install. |
| H-D V-Front Fender Rail |
I removed the front wheel to get the fender bolts off. |
| H-D V-Front Fender Skirt |
Replaces the stock one with supplied hardware |
| H-D Nostalgic Rider Footboard
Insert |
Easy replacement |
| H-D Nostalgic Brake Pedal Pad |
Easy install |
| H-D Six Shooter Fuel Cap and LED Gauge
#75087-04 |
Pretty easy install. Hard to get to
the connector but I just raised the tank a little. |
| H-D Heritage Handlebars |
Direct replacement. Improved my riding comfort. |
| H-D Water bottle and pouch for saddlebag guard rails #
92058-05 |
Easy to reach water for longer rides. |
| H-D Bar and Shield Soft Lowers |
Snap on and off. Provides wind
protection on cold days. |
| H-D Chrome Wind Deflectors #58121-85B |
Reduces helmet buffeting |
| Garmin ZUMO 550 GPS |
Installed using included handlebar mount. |
| Custom Engraved Derby Cover |
Custom done by
Gordon's
|
|
Clearview
Windshield. with the recurve and gray tint |
The recurve works and now I look over the
windshield. |
Mustang Solo Seat with backrest and fender bib.
Matching Mustang 13.5 inch passenger seat. |
So far the best seat I have tried. Sundowner was
OK but pushed me to far forward. |
| Sheepskin Buttpad from
Alaska Leather |
It makes a big difference when riding
longer rides. Very comfortable. |
| RIVCO Air Horn |
Looks good and sounds great. Easy
install. 15-20 minutes and I was done |
| K&N RK3909 high flow Air Filter kit |
Lots of small screws and spacers but pretty easy
install. |
| Kuryakyn ISO Grips |
Consult the repair manual for the right
hand side because of the throttle cables. The left on glues on. |
| Kuryakyn
Helmet Lock for the ISO Grips |
Easy to use helmet lock. |
| Kuryakyn Switchblade Road Pegs |
Bolt on to the engine guard. |
| Kuryakyn Boot Guard Turn down model |
Bolts right on to the floorboard. Helps
keep your boot off the exhaust pipe. |
|
MUTH Signal Mirrors |
Replaces the stock ones. Adds signal indicators
forward and to the rear. |